- Backbox: 5.80 in. deep with keyhole mounting slots on 16 in. centers, center opening to mount over electrical pull boxes, 1/4-20 ground stud, embossed dimples on back plane for installation of board-mounted accessories, laser-cut knockout panels on top/bottom, two keyed side locks.
- Front Mounting Section: Fully gusseted corners, triple formed wrap design mounts to backbox from inside with two heavy duty spring-loaded L-pins, knockouts for wireless antennas, 1 pair adjustable mounting rails tapped 10-32, integral rails on EIA spacing for mounting or lacing
- Black wrinkle textured powder epoxy finish
- Black Pilot Point screws with captive washers
- Rack Space: 18U
- Height: 37.50 in.
- Width: 23.06 in.
- Depth: 32.05 in. (29 in. usable)
- Load Capacity: 250 lbs.
The EIA compliant, welded sectional wall rack shall be Lowell LWR-1832, which shall consist of a backbox and mounting section made in the USA from 16 gauge certified U.S. steel. Overall measurements shall be 37.50″H x 32.05″D x 23.06″W , providing 18U panel space. The mounting section shall be 26.06″D with triple formed side-to-bottom, side-to-top wrapped construction to achieve strength equivalent to 3/16″ thick steel. It shall feature side vents, one pair adjustable mounting rails tapped 10-32, four knockouts for antennas (top and bottom), and integral rails on EIA spacing (top and bottom). The mounting section shall attach to the backbox on the inside with two heavy duty, spring-loaded L-pins (self seating, positive locking), which can be attached on either side to alter swing orientation. The backbox shall be 5.80″D with keyhole mounting slots on 16″ centers, a 10″x 10″ rear opening, embossed dimples and lacing points on the back plane, knockout panels with combination knockouts (1/2″–3/4″, and 1″–1-1/2″), and two keyed side locks. The rack shall have a black wrinkle powder epoxy finish.
