Rackmount Switches:

Maintained Closure Switch:

Description: Low-voltage switch set into 19" (1U) EIA panel. Switch activates equipment connected with a remote power control or sequencer. The maintained closure is for single-switch applications. specs

Model No's.:

• RPSB-R: one LED, rocker switch (pictured at left)
• RPSB-KR: one LED, key switch

Features:

• LED shows system status (requires three-conductor wire)
• Rear connection termination strips
• Typically used with remote power controls (RPC-series) or sequencers (SCS-4) — order separately.
• Single-pole, single-throw (SPST)
• Made in USA

Momentary Closure Switch:

Description: Low-voltage switch set into 19" (1U) EIA panel. Switch activates equipment connected with a remote power control or sequencer. The momentary closure is for applications that use multiple switches to activate equipment. specs

Model No's.:

• RPSB-MR: one LED, rocker switch
• RPSB2-MR: two LEDs, rocker switch (pictured at left)
• RPSB-MKR: one LED, key switch
• RPSB2-MKR: two LEDs, key switch

Features:

• LED shows system status
• Rear connection termination strips
• Models with one LED are typically used with remote power controls (RPC-series) or sequencers (SCS-4) — order separately.
• Models with two LEDs are typically used with SCS-8 or SCS-4R or MSM2 (see below) — order separately.
• Single-pole, single-throw (SPST)
• Made in USA

Switch Converter:

Momentary Switch Module:

Description: Low-voltage momentary switch module (for use with RPC remote controls or SCS-4 sequencer) converts a maintained switch (required in RPC controls) to momentary closure function, allowing multiple switch locations. NOTE: Sequencer SCS-4 requires this module if used with multiple switches. Other sequencer models may already include a momentary closure function. specs

Model No.: MSM2

Features:

• Includes provisions for dual LED remote switches and alternate switching of RPC units or sequencers. The MSM2 also has greater switching capacity.
• Remote Switch Maximum: Six with RPCs, or 12 with SCS-4 (see spec sheet)
• Compact unit (5" x 3.28" x 1.69")
• Steel chassis with mounting holes and connection diagram
• Black finish
• Made in USA