products

Wall-Mount Racks

USA FlagWall-mount racks can help save floor space and come in a variety of styles and sizes to address different applications. Made in the USA.

LWBR Series: Wall Rack with Base

Specs   |   CAD Drawings   |   Photos   |   Accessories

The LWBR wall-mount rack is unique in that it mounts to a wall but includes a support base that actually adds another 4 rack units to capacity. The rack swings open easily using a single-release grasp,  pivots smoothly on internal spring-loaded hinges and stainless steel ball transfers set into the base, and then shuts securely with a slam latch closure. Welded 16-gauge steel construction with beveled corners and black wrinkle powder epoxy finish. Adjustable mounting rails, tapped 10-32. Made in the USA with certified U.S. steel. 24-44 rack units. 

share

LWER Series: Economy Wall Rack

Specs   |   CAD Drawings   |   Photos   |   Accessories

The economical LWER series is a stationary wall rack providing a contemporary solution for small system installations in schools and offices. It's well-suited for light to medium loads where quick access to cables may not be a priority. The wall-mount rack includes a mounting bracket, solid front door with keyed lock, and fixed-position mounting rails, tapped 10-32. Black powder epoxy finish. Made in the USA with certified U.S. steel. 7-10 rack units.

share

LWR Series: Wall Rack

Specs   |   CAD Drawings   |   Photos   |   Accessories

LWR Series racks are heavy duty, sectional wall-mount racks with a steel backbox and separate front cabinet, boxed separately so the back can be field-installed while the front is loaded at the shop. Includes adjustable front mounting rails, tapped 10-32 and integral rails on the top and bottom. Black powder epoxy finish. Made in the USA with certified U.S. steel. 7-35 rack units. 

share

LWRF-418: Short Wall Rack

Specs   |   Photos

Short 4U wall-mount rack is a smart contemporary solution for small system installations requiring an open front for quick access to mounted electronics. The welded 16-ga. steel rack includes 1-pair of fixed-position front mounting rails, vented sides and a separate wall bracket. Black wrinkle powder epoxy finish. Made in the USA.

share

LWTCR Series: Tilt Wall Rack

Specs   |   CAD Drawings   |   Photos   |   Accessories

The LWTCR tilt-out rack series is ideal for housing amplifiers, small mixers, PA systems, or consumer electronics in educational facilities, institutional buildings, and house of worship venues. The wall-mount rack's front tilts down 90 degrees to lower equipment to a horizontal position for activation or servicing. Oil-filled dampers provide a controlled release when lowering equipment. Available in recessed and surface-mount models. Made in the USA with certified U.S. steel.

share

LWTR Series: Tilt Wall Rack

Specs   |   CAD Drawings   |   Photos   |   Accessories

The LWTR wall-mount rack series is a practical rack that stores equipment out of the way in a vertical position. The front panel tilts down 90 degrees to lower equipment to a horizontal position for activation or servicing. Available in recessed and surface-mount models. Install in brick, concrete block, or stud wall construction. Made in the USA with certified U.S. steel.

share

LWSR Series: Swing Wall Rack

Specs   |   CAD Drawings   |   Photos   |   Accessories

The economical LWSR two-part rack series features a 16-gauge steel backbox and front mounting section. The mounting section attaches to the backbox with two heavy-duty bolts through steel fasteners with securing nuts. Fixed position front mounting rails, tapped 10-32, remain in the factory-mounted position. Made in the USA with certified U.S. steel. 7-16 rack units. 

share